您现在正在浏览:首页 > 论文 > 机械机电 > 毕业论文-线性输出热膜风速仪的研制

免费下载毕业论文-线性输出热膜风速仪的研制

  • 资源类别:论文
  • 资源分类:机械机电
  • 适用专业:测控技术与仪器
  • 适用年级:大学
  • 上传用户:鸿鹄昊天
  • 文件格式:word
  • 文件大小:2.63MB
  • 上传时间:2011-5-28 14:44:52
  • 下载次数:0
  • 浏览次数:43

安全检测:瑞星:安全 诺顿:安全 卡巴:安全

资料简介

毕业论文-线性输出热膜风速仪的研制,共46页,19221字,该论文是优秀本科毕业论文,内容十分详细,电路图很清晰,还有实物图,具有很好的参考价值。
摘要:文章介绍了一种用于测量风速的组合热膜探头,该探头以热传递原理为基础来测量气体流速。热膜风速仪是将风速信号转变为电信号的一种仪器,其原理是将组合热膜探头置于气流中,气体流经组合热膜探头时带走热量,热耗散的程度取决于气体流速的大小。热量的耗散使加热探头的阻值发生变化从而引起电流变化,风速信号即转变成电信号。对该组合热膜探头的温度特性以及温度补偿性能进行了实验研究,并给出了用该探头进行气体流速测量的实验结果,结果证明该组合热膜探头在微小流速测量中具有较高的灵敏度,弥补了毕托管在低速情况下测量误差较大的问题。由于其输出特征曲线是非线性的,会直接影响风速仪的精度,所以运用单片机处理器电路,编写系统主监控程序和线性化程序,设计了可以将组合热膜探头输出特性曲线线性化处理的风速仪。
关键词:组合热膜探头;流速测量;温度补偿;一致性;线性化
Abstract: This paper introduces an assembled hot-film probe applied on measuring the velocity of gas flow, which is based on the principle of transferring the heat. Hot-film anemometer is an instrument which transforms the wind speed signal into electrical signal, the principle is the assembled hot-film probe placed in airflow, the assembled hot-film probe of heat emission in the flow is relate to wind speed, whereas the heat emission led to the changes of resistance caused by the changes of probe temperature, wind speed signal is transformed into electrical signal. A large number of tests on the temperature characteristics of the hot-film probe and experimental research on the temperature compensation performance have been carried out .The results of experiment on measuring the velocity of gas flow using this probe have been gained,and the results proved that it is sensitive to measure the low velocity of gas flow using this assembled hot-film probe ,which offsets the problem that pitot type has high error in measuring the low velocity. Since the output characteristic curve is nonlinear, will directly affect the accuracy of anemometer, so the use of single chip processor circuit, compile the main monitoring program and the linear program, design the anemometer that output characteristic curve of the assembled hot-film probe can be linearization.
Keywords: assembled hot-film probe; velocity of flow measuring; temperature– compensation; consistency; linearization

目 次
摘要 I
目次 III
1 绪论 1
1.1 问题的提出 1
1.2 国内外研究现状 2
1.3 工作原理 2
1.4 研究内容和方法 4
1.5 研究意义 5
2 组合热膜探头温度特性模型的建立 6
2.1 组合热膜探头温度特性研究 6
2.2 组合热膜探头的温度补偿设计 8
3 硬件电路设计 11
3.1 流量信号检测电路的设计 11
3.1.1 温度补偿电路设计 11
3.1.2 差动放大电路设计 12
3.1.3 同相比例放大电路设计 13
3.2 信号处理电路设计 13
3.2.1 微处理器的选择 13
3.2.2 A/D接口电路设计 15
3.3 线性输出电路设计 16
3.3.1 电流模式输出 17
3.3.2 电压模式输出 18
3.4 电源电路设计 19
4 软件设计 21
4.1 初始化模块 22
4.2 信号采集模块 22
4.3 计算模块 24
4.3.1 数字滤波处理 24
4.3.2 瞬时流量计算 24
4.4 主监控程序 25
5 风速仪实验研究与分析 26
5.1 热膜探头一致性实验 26
5.2 曲线拟合 28
5.3 流量与电压线性化处理实验 29
5.4 测量结果验证 31
6 总结与展望 32
6.1 总结 32
6.2 研究与展望 32
附录A:风速仪样机实物图 36
作者简历 37
学位论文数据集 38

资料文件预览
共1文件夹,1个文件,文件总大小:3.16MB,压缩后大小:2.63MB
  • 毕业论文-线性输出热膜风速仪的研制
    • Microsoft Word文档毕业论文-线性输出热膜风速仪的研制.doc  [3.16MB]
下载地址
资料评论
注意事项
下载FAQ:
Q: 为什么我下载的文件打不开?
A: 本站所有资源如无特殊说明,解压密码都是www.xuehai.net,如果无法解压,请下载最新的WinRAR软件。
Q: 我的学海币不多了,如何获取学海币?
A: 上传优质资源可以获取学海币,详细见学海币规则
Q: 为什么我下载不了,但学海币却被扣了?
A: 由于下载人数众多,下载服务器做了并发的限制。请稍后再试,48小时内多次下载不会重复扣学海币。
下载本文件意味着您已经同意遵守以下协议
1. 文件的所有权益归上传用户所有。
2. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
3. 学海网仅提供交流平台,并不能对任何下载内容负责。
4. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
5. 本站不保证提供的下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。
返回顶部